ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ УСТАНОВКА

Информация добавлена 08-08-2017

PROCEDURE


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Insert the transmission control cable assembly from the vehicle outside, and attach the 3 claws of the cable retainer.

    2. Install the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the transmission control cable assembly to the transmission control cable bracket with a new clip, and connect the transmission control cable end to the control shaft lever with the nut.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    4. Connect the transmission control cable support with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Turn the socket of the transmission control cable assembly 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

      Note

      Do not over-rotate the socket as it will come off the internal spring and the transmission control cable assembly will not be reusable.

      A01A5NZC06
      *1 Socket *2 Lock Piece
      *a Push in - -

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    6. Install the outer part of the transmission control cable assembly to the shift lever retainer. Check that the socket and lock piece are positioned at original position.

      A01A2NSC09
      *1 Shift Lever Retainer - -
    7. B001U04C09
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    8. B001V85

      Connect the end of the cable to the transmission floor shift assembly.

      Note


      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the pin.

    9. B001U58

      Push the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

  2. INSPECT SHIFT LEVER POSITION

    Click here

  3. INSTALL FRONT CONSOLE BOX (w/ Refrigerated Cool Box)

    Click here