ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ УСТАНОВКА

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.


    1. Clean the bolt and the bolt hole.

    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Install the park/neutral position switch assembly to the manual valve shaft.

    4. Temporarily install the bolt.

    5. A01A3WQC02
      *1 New Lock Washer

      Install a new lock washer and the nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    6. A01A69TE01

      Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

    7. A000A31C03
      *1 Neutral Basic Line
      *2 Groove

      Align the groove with the neutral basic line.

    8. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 10 ft.*lbf }

    9. Using a screwdriver, bend the tabs of the lock washer.

    10. Connect the park/neutral position switch connector.

  2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here