ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ УСТАНОВКА

PROCEDURE

1. INSTALL TRANSMISSION WIRE

   
   

   1. Coat a new O-ring with ATF and install it to the transmission wire.

   2. Install the transmission wire with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   3. Connect the transmission wire connector.

      Tech Tips

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

2. CONNECT TRANSMISSION WIRE

   
   

   1. 

      Connect the 7 connectors to the solenoid valves.

   2. Coat the 2 new O-rings with ATF and install them to the 2 ATF temperature sensors.

   3. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:

      for bolt A

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      for bolt B

      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      Bolt length
      for Bolt A
      12 mm (0.472 in.)
      for Bolt B
      36 mm (1.42 in.)

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

   
   

   1. Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

   2. Install the valve body oil strainer assembly with the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

   Note

   Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and automatic transmission oil pan sub-assembly.

   
   

   1. Install a new gasket and the automatic transmission oil pan sub-assembly with the 20 bolts.

      Torque:

      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

5. ADD AUTOMATIC TRANSMISSION FLUID

   Click here