ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ СНЯТИЕ

PROCEDURE

1. DRAIN AUTOMATIC TRANSMISSION FLUID

   
   

   1. Remove the drain plug and gasket, and drain the ATF.

   2. Install a new gasket and the drain plug.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

   
   

   1. 

      Remove the 20 bolts, automatic transmission oil pan sub-assembly and gasket from the automatic transmission assembly.

      Note

      Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all the oil pan bolts, and carefully remove the automatic transmission oil pan sub-assembly.

   2. Examine the particles in the automatic transmission oil pan sub-assembly.

      
      

      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the automatic transmission assembly.

         Steel (magnetic): bearing, gear and clutch plate wear

         Brass (non-magnetic): bush wear

3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

   
   

   1. 

      Remove the 4 bolts and valve body oil strainer assembly.

      Note

      Be careful as some fluid may leak out of the valve body oil strainer assembly.

   2. Remove the O-ring from the valve body oil strainer assembly.

4. DISCONNECT TRANSMISSION WIRE

   

   
   

   1. Remove the 2 bolts and 2 temperature sensor clamps.

   2. Disconnect the 2 ATF temperature sensors.

   3. Remove the 2 O-rings from the 2 ATF temperature sensors.

   4. Disconnect the 7 connectors from the solenoid valves.

5. REMOVE TRANSMISSION WIRE

   
   

   1. 

      Disconnect the wire connector.

      Tech Tips

      Detach the claw, press down the lever, and disconnect the transmission wire connector.

   2. 

      Remove the bolt and pull out the transmission wire.

   3. Remove the O-ring from the transmission wire.