СТАРТЕР ПОВТОРНАЯ СБОРКА

PROCEDURE

1. Click here

   INSTALL STARTER ARMATURE ASSEMBLY

   
   

   1. Install the starter armature to the starter yoke.

2. Click here

   INSTALL STARTER BRUSH HOLDER ASSEMBLY

   
   

   1. Install the starter brush holder.

   2. Connect the 4 brushes to the starter brush holder.

      
      

      1. Using a screwdriver, hold back the brush spring.

      2. Connect the brush to the starter brush holder.

         Note:

         Check that the positive (+) lead wires are not grounded.

   3. Place a new O-ring in position on the commutator end frame.

   4. Install the commutator end frame with the 2 screws.

      1.5 N*m

      15 kgf*cm

      13 in.*lbf

3. Click here

   INSTALL MAGNET STARTER SWITCH ASSEMBLY

   
   

   1. Apply high-temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.

   2. 

      Insert the steel ball into the starter clutch hole.

   3. Insert the return spring into the starter clutch hole.

   4. Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.

   5. Install the starter drive housing to the magnet starter switch with the 2 bolts.

      5.9 N*m

      60 kgf*cm

      52 in.*lbf

4. Click here

   INSTALL STARTER YOKE ASSEMBLY

   
   

   1. Install a new O-ring to the groove of the starter yoke.

   2. 

      *1	Claw
      *2	Groove

      Align the claw of the starter yoke with the groove of the magnet starter switch.

   3. Install the starter yoke to the magnet starter switch with the 2 bolts.

      5.9 N*m

      60 kgf*cm

      52 in.*lbf

   4. Connect the lead wire to terminal C with the nut.

      5.9 N*m

      60 kgf*cm

      52 in.*lbf