НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ

PROCEDURE

1. REMOVE UPPER RADIATOR SUPPORT SEAL

   Click here

2. REMOVE LOWER FRONT BUMPER COVER

   Click here

3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

4. DRAIN ENGINE COOLANT

   Click here

5. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

6. REMOVE NO. 1 RADIATOR HOSE

   Click here

7. REMOVE NO. 2 RADIATOR HOSE

   Click here

8. REMOVE RADIATOR RESERVOIR ASSEMBLY

   Click here

9. DISCONNECT OIL COOLER TUBE

   Click here

10. REMOVE FAN SHROUD

    Click here

11. REMOVE WATER INLET HOUSING

    
    

    1. Disconnect the throttle body connector.

    2. 

       Disconnect the 5 water by-pass hoses.

    3. Disconnect the oil cooler hose.

    4. Disconnect the No. 2 oil cooler hose.

    5. 

       Remove the 5 bolts and water inlet.

    6. Remove the O-ring from the water outlet pipe.

    7. Remove the gasket from the engine water pump.

12. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

    

    *a	LH:
    *b	RH:

    
    

    1. for Separate Type:

       Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulleys and 2 No. 2 idler pulley cover plates.

    2. for Integrated Type:

       Remove the 2 bolts and 2 No. 2 idler pulleys.

13. DISCONNECT VANE PUMP ASSEMBLY

    
    

    1. 

       Detach the 2 wire harness clamps and disconnect the connector.

    2. 

       Remove the 2 bolts and disconnect the vane pump.

14. REMOVE GENERATOR ASSEMBLY

    Click here

15. REMOVE COOLER COMPRESSOR ASSEMBLY

    Click here

16. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

    Click here

17. REMOVE ENGINE WATER PUMP ASSEMBLY

    
    

    1. 

       Remove the 17 bolts, engine water pump and gasket.