ВПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

Информация добавлена 08-08-2017

PROCEDURE


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT BUMPER COVER LOWER

    Click here

  5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  6. DRAIN ENGINE COOLANT

    Click here

  7. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A000AJXC02
      *1 V-bank Cover Sub-assembly
      *2 No. 1 V-bank Cover Bracket
      *a Pin
      *b Hook

      Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover sub-assembly hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.

  8. REMOVE NO. 1 AIR CLEANER HOSE


    1. B001SO6

      Disconnect the ventilation hose and vacuum hose.

    2. Detach the wire harness clamp.

    3. Remove the bolt and loosen the 2 hose clamps.

    4. Remove the No. 1 air cleaner hose.

  9. REMOVE INTAKE AIR SURGE TANK


    1. B001SU1

      Disconnect the throttle body connector.

    2. Slide the clamp and disconnect the No. 4 water by-pass hose from the water inlet housing.

    3. Slide the clamp and disconnect the No. 5 water by-pass hose from the water inlet housing.

    4. B001P15

      Slide the clamp and disconnect the No. 1 fuel vapor feed hose from the No. 1 vacuum switching valve.

    5. Disconnect the No. 1 vacuum switching valve connector.

    6. Slide the clamp and disconnect the No. 1 ventilation hose from the intake air surge tank.

    7. B001SZR

      Detach the 2 heater hose clamps from the intake air surge tank.

    8. B001V1I

      Remove the 2 bolts and throttle body bracket.

    9. B001P8M

      Using a clip remover, detach the wire harness clamp from the No. 1 surge tank stay.

    10. B001S6P

      Remove the 2 bolts and No. 1 surge tank stay.

    11. B001TJC

      Remove the 2 bolts and No. 2 surge tank stay.

    12. B001URW

      Using an 8 mm hexagon socket wrench, remove the 4 hexagon socket head cap bolts, 2 nuts and intake air surge tank.

    13. Remove the gasket.

  10. REMOVE REAR CYLINDER HEAD COVER

    Click here

  11. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

    Click here

  12. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

    Click here

  13. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

    Click here

  14. REMOVE INTAKE MANIFOLD


    1. B001SV4

      Remove the 4 nuts, 6 bolts, intake manifold and 2 gaskets.