КЛАПАН ПРОДУВКИ АДСОРБЕРА ПРОВЕРКА

PROCEDURE

1. Click here

   INSPECT PURGE VSV

   
   

   1. Inspect the purge VSV.

      
      

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 23 to 26 Ω 1 - Body ground 2 - Body ground Always 10 MΩ or higher

         If the result is not as specified, replace the purge VSV.

         Tip:

         When measuring the coil resistance make sure that the surface temperature of the purge VSV is 20°C.

   2. Check the operation of the purge VSV.

      
      
      1. 

         *1	Port E
         *2	Port F
         *a	Does not flow
         	Air pressure

         Check that air does not flow from port E to port F.

      2. 

         *1	Port E
         *2	Port F
         	Air pressure

         Apply battery voltage to the connector and check the VSV operation.

         OK
         Measurement Condition Specified Condition Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 Air flows from port E to port F

         If the result is not as specified, replace the purge VSV.