ТОПЛИВНЫЙ НАСОС УСТАНОВКА

Информация добавлена 08-08-2017

PROCEDURE


  1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. Apply a light coat of gasoline or grease to a new gasket and install the gasket to the fuel tank.

    2. A01A6SVC01
      *1 Protrusion
      *2 Groove

      Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    3. Install the fuel suction with pump and gauge tube to the fuel tank.

    4. A01NAFFC02
      *1 Start Mark (Fuel Tank Side)
      *2 Start Mark (Retainer Side)

      Put a new retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.

      Tech Tips

      Make sure the start marks on the retainer and fuel tank are aligned and then tighten the retainer.

    5. A01A5UQN03

      Set SST on the retainer.

      SST
      09808-14030

      Tech Tips


      • Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket is not moved out of position.

      • Engage the claws of SST securely with the fuel pump gauge retainer holes to secure SST.

      • Install SST while pressing the claws of SST against the fuel pump gauge retainer (toward the center of SST).

    6. A01A5YEC01
      *1 Fuel Tank Side Mark
      *2 Retainer Side Mark

      Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.

      SST
      09808-14030

      Tech Tips

      Fit the tips of SST onto the ribs of the retainer.

  2. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY AND FUEL RETURN TUBE SUB-ASSEMBLY

    Click here

  3. INSTALL FUEL TANK CUSHION

    Click here

  4. INSTALL FUEL TANK SUB-ASSEMBLY

    Click here