БЛОК ЦИЛИНДРОВ ЗАМЕНА

Информация добавлена 08-08-2017

PROCEDURE


  1. REPLACE TIMING BELT IDLER BRACKET SET RING PIN

    Note

    It is not necessary to remove a straight pin unless it is being replaced.

    B001RSWC02
    *a Front Side *b Rear Side
    *c Upper Side *d Lower Side

    1. Remove the straight pins.

    2. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

      Standard Protrusion Height
      Item Specified Condition
      Pin A 22.5 to 23.5 mm (0.886 to 0.925 in.)
      Pin B 10.5 to 11.5 mm (0.413 to 0.453 in.)
      Pin C 8.5 to 9.5 mm (0.335 to 0.374 in.)
      Pin D 5.5 to 6.5 mm (0.217 to 0.256 in.)