ПРОКЛАДКА ГОЛОВКИ БЛОКА ЦИЛИНДРОВ УЗЛЫ И ДЕТАЛИ
Информация добавлена 08-08-2017 
ILLUSTRATION
| *1 | CHAIN TENSIONER SLIPPER | *2 | CRANKSHAFT TIMING SPROCKET |
| *3 | NO. 1 CHAIN SUB-ASSEMBLY | *4 | NO. 1 CHAIN TENSIONER ASSEMBLY |
| *5 | NO. 1 CHAIN VIBRATION DAMPER | *6 | NO. 1 IDLE GEAR SHAFT |
| *7 | NO. 2 CHAIN VIBRATION DAMPER | *8 | NO. 1 IDLE GEAR |
| *9 | NO. 2 IDLE GEAR SHAFT | *10 | O-RING |
| *11 | CRANKSHAFT TIMING GEAR KEY | - | - |
 |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT | *2 | CAMSHAFT BEARING CAP (for Bank 1) |
| *3 | CAMSHAFT HOUSING SUB-ASSEMBLY RH | *4 | NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY |
| *5 | NO. 2 CAMSHAFT | *6 | NO. 2 CHAIN TENSIONER ASSEMBLY |
| *7 | VALVE LASH ADJUSTER ASSEMBLY | *8 | VALVE STEM CAP |
| *9 | NO. 2 CHAIN SUB-ASSEMBLY (for Bank 1) | *10 | GASKET |
| *11 | CAMSHAFT TIMING GEAR ASSEMBLY (for Bank 1) | *12 | CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY RH (for Bank 1) |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT BEARING CAP (for Bank 2) | *2 | CAMSHAFT HOUSING SUB-ASSEMBLY LH |
| *3 | NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY | *4 | NO. 3 CAMSHAFT |
| *5 | NO. 3 CHAIN TENSIONER ASSEMBLY | *6 | NO. 4 CAMSHAFT |
| *7 | VALVE LASH ADJUSTER ASSEMBLY | *8 | VALVE STEM CAP |
| *9 | NO. 2 CHAIN SUB-ASSEMBLY (for Bank 2) | *10 | CAMSHAFT TIMING GEAR ASSEMBLY (for Bank 2) |
| *11 | GASKET | *12 | CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY LH (for Bank 2) |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *1 | CYLINDER HEAD GASKET | *2 | CYLINDER HEAD LH |
| *3 | CYLINDER HEAD SET BOLT | *4 | CYLINDER HEAD SUB-ASSEMBLY |
| *5 | NO. 2 CYLINDER HEAD GASKET | *6 | REAR WATER BY-PASS JOINT |
| *7 | GASKET | *8 | O-RING |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| *T1 | 1st: 36 (367, 27) 2nd: Turn 90° 3rd: Turn 90° |
- | - |