WASHER NOZZLE (for Rear Side) INSTALLATION


  1. INSTALL REAR WASHER NOZZLE


    1. Engage the 2 claws to install the rear washer nozzle.

    2. Connect the washer hose.

  2. INSPECT REAR WASHER NOZZLE


    1. With the power switch on (READY), check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

      Standard
      Washer fluid hits the windshield in the area shown in the illustration.
      A003W0OE01
      Standard Clearance
      Area Measurement
      A 22 mm (0.866 in.)
      B 6 mm (0.236 in.)
      C 72 mm (2.835 in.)
      D 108 mm (4.252 in.)

  3. ADJUST REAR WASHER NOZZLE


    1. A003XTU

      Using a screwdriver, adjust the direction of the rear washer nozzle.

      Note

      Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

      Tech Tips

      Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.

  4. INSTALL REAR SPOILER SUB-ASSEMBLY

    Click here