WASHER MOTOR (for Rear Side) REMOVAL


  1. REMOVE FRONT WHEEL RH

  2. REMOVE FRONT FENDER LINER RH


    1. A003XBFE01

      Using a screwdriver, turn each pin 90 degrees counterclockwise and remove the 2 pin hold clips.

    2. A003VN9

      Using a 4 mm hexagon wrench, remove the 3 screws.

    3. A003WD4E01

      Remove the 6 screws and bolt.

    4. Remove the 6 clips and 2 grommets and front fender liner RH.

      Tech Tips

      The grommets need to be replaced with new ones because they will break when they are removed.

      Text in Illustration
      *1 Grommet

  3. DRAIN WASHER FLUID


    1. A003XVP

      Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.

      Tech Tips

      Use a container to collect the washer fluid.

  4. REMOVE REAR WASHER MOTOR ASSEMBLY


    1. A003YWE

      Disconnect the connector.

    2. Remove the rear washer motor and pump assembly as shown in the illustration.

      Tech Tips

      Use a container to collect the washer fluid.