REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. Install the rear wiper motor assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A003ZP0E01
      Text in Illustration
      *1 MP Grease

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A003VJ3E01
      Text in Illustration
      *1 Alignment Mark

      Install the rear wiper motor grommet.

      Tech Tips

      Install the grommet with its alignment mark facing up.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A003X58E01
        Text in Illustration
        *1 Wiper Arm Serrations

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor assembly:


      1. A003XNOE01
        Text in Illustration
        *1 Wiper Pivot Serrations

        Clean the wiper pivot serrations with a wire brush.

    4. A003Y29

      Temporarily install the rear wiper arm and blade assembly.

    5. A003XWUE01
      Text in Illustration
      *1 Ceramic Dot

      Install the rear wiper arm and blade assembly with the nut to the position as shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the wiper arm by hand while tightening the nut.

    6. Turn the power switch on (IG).

    7. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

    8. Lift the wiper arm twice after the wiper stops and check the wiper set position.

    9. Turn the power switch off.

  4. INSTALL REAR WIPER ARM HEAD CAP


    1. A003VR4E02

      Engage the 2 claws (B) to the rear wiper arm and blade assembly.

    2. Engage the 2 claws (A) to install the rear wiper arm head cap as shown in the illustration.

  5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. A003XVHE01

      Engage the 13 clips to install the back door trim board assembly.

      Tech Tips

      Engage the clips in the order shown in the illustration.

    2. A003Y7A

      Slide the handle plate of the back door trim board to engage it.

  6. INSTALL BACK DOOR SIDE GARNISH LH


    1. A003XEI

      Engage the 2 clips, 2 claws and guide to install the back door side garnish LH.

  7. INSTALL BACK DOOR SIDE GARNISH RH


    1. A003VMK

      Engage the 2 clips, 2 claws and guide to install the back door side garnish RH.

  8. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A003X12

      Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.