FRONT SEAT ASSEMBLY (for Manual Seat) INSTALLATION


  1. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector and clamp under the seat.

    3. Temporarily install the front seat assembly with the 4 bolts.

    4. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    5. A003ZLBE01

      Tighten the 2 bolts on the front side of the seat.

      Torque:
      37 N*m  { 375 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

    6. Lift up the seat track adjusting handle and move the seat to the foremost position.

    7. A003XQJE01

      Tighten the 2 bolts on the rear side of the seat.

      Torque:
      37 N*m  { 375 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

  2. INSPECT SEAT SLIDE ADJUSTER LOCKS


    1. During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.

  3. INSTALL REAR INNER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. Engage the 2 claws to install the rear inner seat track bracket cover.

  4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. Engage the 2 claws to install the front inner seat track bracket cover.

  6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the front outer seat track bracket cover.

  7. INSTALL FRONT SEAT HEADREST ASSEMBLY

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here

  9. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE


    1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.

  10. INSTALL DECK FLOOR BOX RH


    1. Engage the 6 guides.

    2. Install the deck floor box RH with the clip.

  11. INSTALL REAR NO. 3 FLOOR BOARD


    1. Install the rear No. 3 floor board.

  12. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  13. INSTALL REAR NO. 2 FLOOR BOARD


    1. Install the rear No. 2 floor board.

  14. INSPECT SRS WARNING LIGHT

    Click here