AIRBAG CUT-OFF SWITCH INSTALLATION

Note


  • Use the same procedure for the front passenger side of RHD and LHD vehicles.

  • The procedures listed below are for the front passenger side of an LHD vehicle.


  1. INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A003Y7Y

      Engage the 2 claws to install the airbag cut off switch cylinder sub-assembly.

  2. INSTALL INSTRUMENT SIDE PANEL RH


    1. Connect the connector.

    2. A003YNR

      Engage the 4 guides, clip and 3 claws to install the instrument side panel RH.

  3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE


    1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.

  6. INSTALL DECK FLOOR BOX RH


    1. Engage the 6 guides.

    2. Install the deck floor box RH with the clip.

  7. INSTALL REAR NO. 3 FLOOR BOARD


    1. Install the rear No. 3 floor board.

  8. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  9. INSTALL REAR NO. 2 FLOOR BOARD


    1. Install the rear No. 2 floor board.

  10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  11. INSPECT SRS WARNING LIGHT

    Click here