SEAT POSITION SENSOR REMOVAL

Note


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of an LHD vehicle.


  1. REMOVE FRONT SEAT ASSEMBLY LH

    for Manual Seat: Click here

    for Power Seat: Click here

  2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)


    1. A003YB9E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for 6 Way Seat Type)


    1. A003ZAO

      Remove the screw and vertical adjusting handle.

  4. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)


    1. A003X3J

      Remove the screw.

    2. Disengage the 11 claws and clip, and remove the front seat cushion shield.

  5. REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)


    1. A003VPK

      Separate the wire harness from the 2 hooks.

    2. A003VQZ

      Disconnect the connector.

    3. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.

    4. A003Y0N

      Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.

  6. REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)


    1. A003VNJ

      Separate the wire harness from the 2 hooks.

    2. Disconnect the connector.

    3. A003WDS

      Using a T30 "TORX" socket wrench, remove the "TORX" screw, nut and seat position airbag sensor with the seat slide position sensor protector.

    4. A003Y0N

      Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.