Click here

REAR AIRBAG SENSOR REMOVAL

Click here
Click here
Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing (Click here).

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

  2. Click here

    REMOVE REAR NO. 2 FLOOR BOARD


    1. Remove the rear No. 2 floor board.

  3. Click here

    REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. Click here

    REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  5. Click here

    REMOVE DECK FLOOR BOX RH


    1. A003Z5J

      Remove the clip.

    2. Disengage the 6 guides and remove the deck floor box RH.

  6. Click here

    REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    1. A003VKN

      Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.

  7. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  8. Click here

    REMOVE REAR SEAT ASSEMBLY

    (Click here)

  9. Click here

    REMOVE REAR DOOR SCUFF PLATE


    1. A003ZA0

      Disengage the 4 claws, 2 guides and 2 clips, and remove the rear door scuff plate LH.

  10. Click here

    REMOVE REAR SEAT SIDE COVER RH (for RH Side)


    1. A003X7P

      Disengage the 3 claws and 2 clips, and remove the rear seat side cover RH.

  11. Click here

    REMOVE REAR SEAT SIDE GARNISH


    1. A003WIU

      Remove the clip.

    2. Disengage the 6 claws and remove the rear seat side garnish LH.

  12. Click here

    REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Disconnect the connector.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. A003VCME01

        Push and hold the white housing lock, and slide the outer connector locking sleeve.

        Table 1. Text in Illustration
        *1 Housing Lock *2 Outer Connector Locking Sleeve
        *a Slide *b Push

      2. Push and hold the white housing lock again, and slide the outer connector locking sleeve to disconnect the connector.

    4. Remove the nut and No. 2 side airbag sensor assembly.

      Note:

      Loosen the nut while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly pin (stopper) is easily damaged.