FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL NO. 3 INSTRUMENT PANEL WIRE


    1. A003XQQ

      Connect the 2 airbag connectors to the instrument panel passenger airbag assembly.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    2. Push in the 2 locks to install the No. 3 instrument panel wire to the instrument panel passenger airbag assembly.

  2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. Engage the 3 hooks.

    2. Push the instrument panel passenger airbag assembly to engage the 3 hooks.

    3. Install the 2 screws to install the instrument panel passenger airbag assembly.

  3. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY


    1. Engage the 5 guides.

      Note

      Do not damage the upper instrument panel assembly.

    2. Engage the 12 claws.

      A003WKLE01

    3. Install the upper instrument panel assembly with the 2 bolts <A> and 2 screws <B>.

      Torque:
      Bolt <A>
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    4. Engage the clamp.

    5. Connect each connector.

  4. CONNECT NO. 3 INSTRUMENT PANEL WIRE


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A003X5J

      Connect the connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Navigation System)

    Click here