Click here

FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

Click here
Click here
  1. Click here

    PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing (Click here).

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

  2. Click here

    REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Navigation System)

    (Click here)

  3. Click here

    DISCONNECT NO. 3 INSTRUMENT PANEL WIRE


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A003ZUWE01

      Slide the slider to release the lock, and then disconnect the connector.

      Table 1. Text in Illustration
      *1 Slider
      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  4. Click here

    REMOVE UPPER INSTRUMENT PANEL ASSEMBLY


    1. Disconnect each connector.

    2. A003V3LE01

      Disengage the clamp.

      Table 2. Text in Illustration
      *A w/ Navigation System - -
    3. A003WVJE01

      Remove the 2 bolts <A> and 2 screws <B>.

      Table 3. Text in Illustration
      *1 Bolt <A> *2 Screw <B>

    4. Disengage the 12 claws.

    5. A003WWYE01

      Disengage the 5 guides and remove the upper instrument panel assembly as shown in the illustration.

      Note:

      Do not damage the upper instrument panel assembly.

  5. Click here

    REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


    1. A003W08

      Remove the 2 screws.

    2. A003YNSE01

      Using a screwdriver with the tip wrapped with protective tape, lean the instrument panel and disengage the 3 hooks as shown in the illustration.

      Table 4. Text in Illustration
      *1 Protective Tape
      Note:

      Do not damage the deployment surface of the instrument panel passenger airbag assembly.

    3. A003XS4

      Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly.

  6. Click here

    REMOVE NO. 3 INSTRUMENT PANEL WIRE


    1. A003XLEE01

      Using a screwdriver with the tip wrapped with protective tape, release the 2 airbag connector locks.

      Table 5. Text in Illustration
      *1 Protective Tape

    2. Disconnect the 2 airbag connectors to remove the No. 3 instrument panel wire from the instrument panel passenger airbag assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.