SPIRAL CABLE REMOVAL


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE STEERING COLUMN COVER

    Note

    Removing the steering column cover in the incorrect order will cause the parts to break.


    1. A003ZEW

      Remove the 2 screws.

    2. A003ZVR

      Push the right and left sides of the steering column cover (lower side) to disengage the 4 claws.

    3. A003XDK

      Insert fingers into the opening of the tilt lever of the steering column cover (lower side) to disengage the 2 claws and remove the steering column cover (lower side).

      Tech Tips

      Spread the claws to disengage them.

    4. A003WUH

      Disengage the 4 clips and 2 guides from the steering column cover (upper side).

    5. A003XIV

      Disengage the 2 claws to remove the steering column cover (upper side).

  3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with the auxiliary battery connected and the power switch on (IG).

    • Do not rotate the spiral cable without the steering wheel with the auxiliary battery connected and the power switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

    • Do not remove the steering sensor from the spiral cable.


    1. A003XMJE01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect the other connector from the spiral cable with sensor sub-assembly.

    3. A003YQE

      Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.