CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A003XA0E01
      Text in Illustration
      *1 Waterproof Sheet

      Install the airbag sensor assembly with the 3 bolts.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. A003Y3B

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installation parts of the airbag sensor assembly.

  2. INSTALL NO. 5 DISC PLAYER BRACKET (w/ Navigation System for DVD)


    1. A003XDUE01

      Install the No. 5 disc player bracket with the 4 bolts.

      Note

      Tighten the 4 bolts in the order shown in the illustration.

    2. Engage the clamp.

  3. INSTALL MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD)


    1. Install the multi-media module assembly with the 4 bolts.

    2. Connect the 2 connectors.

  4. INSTALL NO. 3 CONSOLE BOX MOUNTING BRACKET (w/ Navigation System for DVD)


    1. Engage the 3 guides.

    2. Install the No. 3 console box mounting bracket with the 4 bolts <A>.

    3. Engage the clamp.

  5. INSTALL CONSOLE BOX LH


    1. Engage the guide and 2 claws.

    2. Engage the 3 clips.

    3. Install the console box LH with the bolt <A> and clip.

  6. INSTALL CONSOLE BOX INSERT


    1. Engage the 2 claws and 2 clips to install the console box insert.

  7. INSTALL CONSOLE BOX RH


    1. Engage the guide and 2 claws.

    2. Engage the 3 clips.

    3. Install the console box RH with the bolt <A> and clip.

  8. INSTALL FRONT NO. 2 CONSOLE BOX INSERT


    1. Engage the 5 claws to install the front No. 2 console box insert.

  9. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Connect each connector.

    2. Engage the clamp.

    3. Engage the 2 guides and 6 claws to install the integration control and panel assembly.

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A003X2P

      Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.

  11. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  12. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here