CENTER AIRBAG SENSOR ASSEMBLY REMOVAL


  1. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  2. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A003XQZ

      Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A003WBB

      Disengage the 6 claws and 2 guides.

    2. Disengage the clamp.

    3. Disconnect each connector and remove the integration control and panel assembly.

  5. REMOVE CONSOLE BOX INSERT


    1. A003Z6E

      Disengage the 2 clips and 2 claws, and remove the console box insert.

  6. REMOVE CONSOLE BOX LH


    1. A003WSO

      Remove the bolt <A>.

    2. Using a clip remover, remove the clip.

    3. Using a clip remover, disengage the 3 clips.

    4. Disengage the 2 claws and guide, and remove the console box LH.

  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT


    1. A003W1J

      Disengage the 5 claws and remove the front No. 2 console box insert.

  8. REMOVE CONSOLE BOX RH


    1. A003VY3

      Remove the bolt <A>.

    2. Using a clip remover, remove the clip.

    3. Using a clip remover, disengage the 3 clips.

    4. Disengage the 2 claws and guide, and remove the console box RH.

  9. REMOVE AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A003W85

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. A003XA0

      Remove the 3 bolts and airbag sensor assembly.