FRONT DOOR COURTESY SWITCH INSTALLATION


  1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    1. Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the bolt.

      Torque:
      6.3 N*m  { 64 kgf*cm, 56 in.*lbf }

    2. Connect the connector.

  2. INSTALL CENTER PILLAR LOWER GARNISH


    1. Engage the 4 claws and 2 clips to install the center pillar lower garnish LH.

  3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Install the floor end of the front seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    2. Check if the ELR locks.

      Note

      The check should be performed with the outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  4. INSTALL LAP BELT OUTER ANCHOR COVER


    1. Engage the 3 claws to install the lap belt outer anchor cover.

  5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    for LH Side: Click here

    for RH Side: Click here

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    for LH Side: Click here

    for RH Side: Click here

  7. INSTALL REAR DOOR SCUFF PLATE


    1. Engage the 4 claws, 2 guides and 2 clips to install the rear door scuff plate LH.

  8. INSTALL FRONT DOOR SCUFF PLATE


    1. Engage the 4 claws, 2 guides and 4 clips to install the front door scuff plate LH.