ELECTRICAL KEY OSCILLATOR (for Center Floor) INSTALLATION


  1. INSTALL NO. 2 ELECTRICAL KEY OSCILLATOR


    1. Connect the connector.

    2. Install the No. 2 electrical key oscillator with the bolt.

      Note

      Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.

    3. Install the 2 clips to the floor carpet.

  2. INSTALL REAR SEAT CUSHION LOCK HOOK


    1. A003YR7

      Engage the claw to install a new rear seat cushion lock hook.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure the LH side and RH side.

  3. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. A003XOT

      Pass the rear center seat outer belt assembly through the rear seat cushion assembly.

    3. Install the rear center seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    4. A003W09

      Engage the guide as shown in the illustration.

    5. Pass the rear seat inner with center belt assembly LH and rear seat inner belt assembly through the rear seat cushion assembly as shown in the illustration.

      A003Z3XE01
      Text in Illustration
      *1 Rear Seat Inner Belt Assembly *2 Rear Seat Inner with Center Belt Assembly LH
    6. A003YOA

      Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

    7. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.