ELECTRICAL KEY OSCILLATOR (for Center Floor) REMOVAL


  1. REMOVE REAR SEAT CUSHION ASSEMBLY


    1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

      Note

      Follow the instructions below carefully as the cushion frame can be deformed easily.


      1. A003ZN5E01
        Text in Illustration
        *1 Hook
        *2 Guide

        Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

      2. Repeat the step above for the other hook.

    2. Disengage the guide of the seat cushion from the seatback.

    3. A003YWG
      Standard Measurement
      *a 100 mm (3.94 in.) or less

      Remove the bolt and disconnect the rear center seat outer belt assembly.

    4. Pull out the rear center seat outer belt assembly from the rear seat cushion assembly.

    5. Remove the rear seat cushion assembly.

  2. REMOVE REAR SEAT CUSHION LOCK HOOK


    1. A003Y4L

      Disengage the claw and remove the rear seat cushion lock hook.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure the LH side and RH side.

  3. REMOVE NO. 2 ELECTRICAL KEY OSCILLATOR


    1. A003XCH

      Remove the 2 clips from the floor carpet.

    2. A003X6I

      Remove the bolt.

    3. Disconnect the connector and remove the No. 2 electrical key oscillator.

      Note

      Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.