INTRUSION SENSOR REMOVAL


  1. REMOVE MAP LIGHT ASSEMBLY


    1. Open the overhead console.

    2. A003VMOE01

      Disengage the 4 clips and 3 guides as shown in the illustration.

    3. Disconnect the connector and remove the map light assembly.

  2. REMOVE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/o Sliding Roof)

    Note

    When replaced the intrusion sensor (theft warning ultrasonic sensor), eliminate static electricity by touching the vehicle body to prevent components from being damaged.


    1. w/ Microphone:


      1. A003WZP

        Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

        Tech Tips

        Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

      2. A003X2A

        Disconnect the connector and disengage the clamp.

    2. A003ZKH

      Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

      Tech Tips

      Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

    3. A003XUM

      Remove the 2 screws and disconnect the connector.

    4. Disengage the 2 clamps.

    5. A003YZW

      Remove the 7 screws and cover.

    6. A003VPF

      Remove the board.

    7. A003ZN1

      Remove the 4 screws and intrusion sensor (theft warning ultrasonic sensor) from the base.

  3. REMOVE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/ Sliding Roof)

    Note

    When replaced the intrusion sensor (theft warning ultrasonic sensor), eliminate static electricity by touching the vehicle body to prevent components from being damaged.


    1. A003ZHZ

      Remove the 2 screws and disconnect the connector.

    2. A003VCZ

      Disengage the 6 clamps.

    3. w/ Microphone:


      1. A003V9C

        Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

        Tech Tips

        Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

      2. A003VB7

        Disconnect the connector and disengage the clamp.

    4. A003V5N

      Remove the 7 screws and cover.

    5. A003VPF

      Remove the board.

    6. A003ZN1

      Remove the 4 screws and intrusion sensor (theft warning ultrasonic sensor) from the base.