THEFT DETERRENT SYSTEM, Diagnostic DTC:B2761

DTC Code	DTC Name
B2761	Intrusion Sensor Internal Circuit Malfunction

DESCRIPTION

The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).

If a problem is detected in the signals transmitted and received by the intrusion sensor (theft warning ultrasonic sensor), or if the transmission or reception circuits malfunction, the intrusion sensor (theft warning ultrasonic sensor) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.

DTC No.	DTC Detection Condition	Trouble Area
B2761	Intrusion sensor outputs signal for sensor malfunction	Map light assembly Intrusion sensor (theft warning ultrasonic sensor) Main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

PROCEDURE

CHECK FOR DTC
1. Clear the DTCs Click here.
2. Turn the power switch on (IG), then off.
3. Set the theft deterrent system to "ARMED STATE".
4. Check that the security indicator changes from illuminated to blinking.
5. Set the theft deterrent system to "DISARMED STATE".
6. Check for DTCs Click here.
  
  OK
  
  DTC B2761 is not output.
NG
REPLACE MAP LIGHT ASSEMBLY Click here

OK

USE SIMULATION METHOD TO CHECK Click here
REPLACE MAP LIGHT ASSEMBLY
1. Replace the map light assembly Click here.
NEXT
CHECK FOR DTC
1. Clear the DTCs Click here.
2. Turn the power switch on (IG), then off.
3. Set the theft deterrent system to "ARMED STATE".
4. Check that the security indicator changes from illuminated to blinking.
5. Set the theft deterrent system to "DISARMED STATE".
6. Check for DTCs Click here.
  
  OK
  
  DTC B2761 is not output.
NG
REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) Click here

OK

END (MAP LIGHT ASSEMBLY WAS DEFECTIVE)
REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR)
1. Replace the intrusion sensor (theft warning ultrasonic sensor) Click here.
NEXT
CHECK FOR DTC
1. Clear the DTCs Click here.
2. Turn the power switch on (IG), then off.
3. Set the theft deterrent system to "ARMED STATE".
4. Check that the security indicator changes from illuminated to blinking.
5. Set the theft deterrent system to "DISARMED STATE".
6. Check for DTCs Click here.
  
  OK
  
  DTC B2761 is not output.
NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

OK

END (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) WAS DEFECTIVE)