| DTC Code | DTC Name |
|---|---|
| B2790 | ID BOX EEPROM Malfunction |
DESCRIPTION
When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B2790 | An internal malfunction occurs in the ID code box (immobiliser code ECU) (EEPROM access malfunction) (1 trip detection logic*). |
|
An immobiliser set/unset operation is performed (the power switch is turned off or on (IG) while carrying the key). |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
|
- |
| DTC Code | Data List and Active Test |
|---|---|
| B2790 | - |
INSPECTION PROCEDURE
Note
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
After performing repair, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
PROCEDURE
REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
Replace the ID code box (immobiliser code ECU).
| NEXT |
|
CLEAR DTC
Clear the DTCs Click here.
| NEXT |
|
REGISTER RECOGNITION CODES
Register the recognition codes in the ECUs.
| NEXT |
|
REGISTER ECU COMMUNICATION ID
Register the ECU communication ID.
| NEXT |
|
CHECK FOR DTC
Check for DTCs Click here.
Tech Tips
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
| OK |
|---|
| DTC B2790 is not output. |
| NG |
|
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
| OK |
|
END (ID CODE BOX (IMMOBILISER CODE ECU) WAS DEFECTIVE)