DOOR CONTROL TRANSMITTER REMOVAL


  1. REMOVE TRANSMITTER BATTERY (for Standard)

    Note

    Take extra care when handling these precision electronic components.


    1. A003WP7

      Push and hold the release knob in the direction indicated by the arrow shown in the illustration. Then take the mechanical key out of the case.

    2. for Type A:


      1. A003WNFE01
        Text in Illustration
        *1 Protective Tape

        Insert a precision screwdriver into the gap, and turn the screwdriver to detach the cover.

        Tech Tips

        Tape the screwdriver tip before use.

      2. A003W2XE01
        Text in Illustration
        *1 Protective Tape

        Insert a screwdriver into the gap and remove the battery (lithium battery: CR1632).

        Note


        • Do not push the terminals with your finger.

        • Do not forcibly pry up the battery. The terminals may be damaged.

        • Do not touch the battery with wet hands. Water may cause rust.

        • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

        • To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.

        Tech Tips

        Tape the screwdriver tip before use.

    3. for Type B:


      1. A003W1H

        Disengage the claw and remove the slide transmitter housing cover as shown in the illustration.

      2. A003YH3

        Remove the battery cover with 4 screws.

      3. A003ZDV

        Insert a screwdriver into the gap and remove the battery (lithium battery: CR1632).

        Note


        • Do not push the terminals with your finger.

        • Do not forcibly pry up the battery. The terminals may be damaged.

        • Do not touch the battery with wet hands. Water may cause rust.

        • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

        • To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.

  2. REMOVE TRANSMITTER (CARD KEY) BATTERY (for Card Type)

    A003ZE6

    1. Lightly hold and pull the transmitter cover out in the direction shown by the arrow in the illustration.

      Note

      Do not insert a screwdriver etc. between the case and transmitter cover and forcefully bend the transmitter cover. This will deform the transmitter cover.

      Tech Tips


      • If the transmitter cover is held too firmly, it becomes harder to pull out.

      • If the transmitter cover is slippery and it is difficult to pull out, use non-slip gloves to pull the cover out.

    2. A003YVR

      Remove the transmitter (card key) battery (lithium battery: CR2412).