LIN COMMUNICATION SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Main Body (Main Body ECU (Multiplex Network Body ECU))
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Communication D-Door Motor Connection status between power window regulator motor assembly (for driver side) and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication P-Door Motor Connection status between power window regulator motor assembly (for front passenger side) and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication RR-Door Motor Connection status between power window regulator motor assembly (for rear RH side) and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication RL-Door Motor Connection status between power window regulator motor assembly (for rear LH side) and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication Slide Roof*1 Connection status between sliding roof ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication Master SW Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.
      Communication Double Locking*2 Connection status between double lock door control relay assembly and main body ECU (multiplex network body ECU)/OK or STOP

      OK: Connected

      STOP: Not Connected

      		 DTC is output if an error occurs in LIN communication.

      • *1: w/ Sliding Roof System

      • *2: w/ Double Locking System