PARKING ASSIST MONITOR SYSTEM Guide Lines and Buttons are not Displayed for All Display Modes

DESCRIPTION

The multi-media module receiver assembly receives back door open/close signals from the main body ECU (multiplex network body ECU) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when performing back camera position setting while the back door is open, a back door open warning message will be displayed on the screen and back camera position setting will be canceled.

Tech Tips

Check the parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.)

WIRING DIAGRAM

A003Z3OE15

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. READ VALUE USING INTELLIGENT TESTER


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Back Door Courtesy SW Back door courtesy switch signal/ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 -
      OK
      The back door courtesy switch functions as specified in the normal condition column.

    NG

    INSPECT BACK DOOR LOCK ASSEMBLY Click here

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

  2. INSPECT BACK DOOR LOCK ASSEMBLY


    1. Remove the back door lock assembly Click here.

    2. Inspect the back door courtesy switch built into the back door lock assembly Click here.


    NG

    REPLACE BACK DOOR LOCK ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Disconnect the Q17 back door lock assembly connector.

    2. Disconnect the H16 main body ECU (multiplex network body ECU) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Q17-2 (+) - H16-19 (BCTY) Always Below 1 Ω
      Q17-1 (E) - Body ground Always Below 1 Ω
      Q17-2 (+) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here