Click here

PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1694

Click here
Click here
DTC Code DTC Name
C1694 Steering Angle Initialization Incomplete
Click here

DESCRIPTION

This DTC is stored when the multi-media module receiver assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. DTC Detection Condition Trouble Area
C1694 Maximum steering angle has not been memorized (steering angle setting is incomplete)

  • Steering angle setting

  • Multi-media module receiver assembly
Click here

INSPECTION PROCEDURE

Note:

  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

Click here

PROCEDURE


  1. Click here

    ADJUST SETTINGS (STEERING ANGLE SETTING)


    1. Perform steering angle setting.


      1. Steering angle setting (Click here)


  2. Click here

    CHECK DTC OUTPUT


    1. Clear the DTCs (Click here).

    2. Check for DTCs (Click here).

      OK
      DTC C1694 is not output.
      Tip:

      • If DTC C1694 is output, perform the steering angle setting again.


      • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the multi-media module receiver assembly.


  3. Click here

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLYClick here

  4. Click here

    END