G-BOOK SYSTEM Emergency Call Switch Indicator Circuit

WIRING DIAGRAM

A003WUEE03

INSPECTION PROCEDURE

Tech Tips

When replacing the telematics transceiver, perform the vehicle contract setting Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY)


    1. Disconnect the H145 telematics transceiver connector.

    2. Disconnect the T6 map light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H145-11 (IND1) - T6-19 (IND1) Always Below 1 Ω
      H145-12 (IND2) - T6-18 (IND2) Always Below 1 Ω
      H145-26 (SIG-) - T6-16 (GND) Always Below 1 Ω
      H145-11 (IND1) - Body ground Always 10 kΩ or higher
      H145-12 (IND2) - Body ground Always 10 kΩ or higher
      H145-26 (SIG-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT MAP LIGHT ASSEMBLY


    1. Disconnect the T6 map light assembly connector.

    2. Connect 2 dry-cell batteries in series.

    3. A003WVHE03
      Text in Illustration
      *a

      Component without harness connected

      (Map Light Assembly)

      Connect a positive (+) lead to terminal T6-19 (IND1) or T6-18 (IND2), and a negative (-) lead to terminal T6-16 (GND) of the map light assembly connector.

    4. Check if the illumination for the emergency call switch comes on.

      OK
      The red indicator comes on when the positive (+) lead from the batteries is connected to terminal T6-19 (IND1) and the negative (-) lead is connected to terminal T6-16 (GND).
      The green indicator comes on when the positive (+) lead from the batteries is connected to terminal T6-18 (IND2) and the negative (-) lead is connected to terminal T6-16 (GND).

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here

    OK

    REPLACE TELEMATICS TRANSCEIVER Click here