NAVIGATION SYSTEM (for HDD) Voice is not Recognized

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CHECK NAVIGATION SETTING

   
   
   1. 

      Display the "Voice Settings" screen.

   2. Check that "Voice Recognition Guidance" is not "Off".

      OK
      "Voice Recognition Guidance" is not "Off".

      Table 1. Text in Illustration

      *a

      Example

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK MICROPHONE (OPERATION CHECK)

   
   
   1. 

      Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

   2. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

   3. Select the recording switch and perform voice recording.

      Tip:
      

      • Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.

      • Voice can be recorded up to 5 seconds.

   4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

      OK
      All check results are normal.

      Table 2. Text in Illustration

      *a	Microphone Input Level Meter
      *b	Recording Switch
      *c	Stop Switch
      *d	Play Switch
      *e	Recording Indicator

   
   
   • OKClick here
   • NGClick here
3. Click here

   REPLACE HARD DISK DRIVE

   
   

   1. Replace the hard disk drive (Click here).

   2. Check that voice recognition is normal.

      OK
      Voice can be recognized normally.

   
   
   • OKClick here
   • NGClick here
4. Click here

   END

5. Click here

   TURN VOICE RECOGNITION GUIDANCE "On"

6. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

7. Click here

   REPLACE NAVIGATION COMPUTER SUB-ASSEMBLYClick here