NAVIGATION SYSTEM Navigation Receiver Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the multi-media module receiver assembly.

WIRING DIAGRAM

A003YQQE17

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY POWER SOURCE)


    1. Disconnect the H147 multi-media module receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H147-12 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H147-17 (+B1) - H147-12 (GND1) Power switch off 11 to 14 V
      H147-16 (ACC1) - H147-12 (GND1) Power switch on (ACC) 11 to 14 V
      H147-15 (IG) - H147-12 (GND1) Power switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here