STEREO JACK ADAPTER ASSEMBLY REMOVAL


  1. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. Open the glove compartment door.

    2. A003XK6

      Using a moulding remover, disengage the 7 claws and 4 guides, and remove the lower center instrument panel finish panel as shown in the illustration.

  2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH


    1. A003WH5

      Disengage the 5 claws, clip and 2 guides, and remove the upper No. 2 console panel garnish.

  3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH


    1. A003XQR

      Disengage the 4 claws, clip and 3 guides, and remove the upper No. 1 console panel garnish.

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Open the console compartment door.

    2. Using a moulding remover, disengage the 9 claws of the vehicle rear side.

      A003XLPE01
      Text in Illustration
      *a Protective Tape - -

    3. Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws of the vehicle front side as shown in the illustration.

    4. Disengage the clamp.

    5. Disconnect each connector and remove the upper console panel sub-assembly.

  5. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. A003VQD

      Disengage the 2 claws and remove the No. 1 stereo jack adapter assembly.