AUDIO AND VISUAL SYSTEM (w/o Navigation System) Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU

DESCRIPTION

The multi-media interface ECU assembly sends the sound signal to the radio receiver assembly through this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

WIRING DIAGRAM

A003YV9E07

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU ASSEMBLY)


    1. Disconnect the radio receiver assembly and multi-media interface ECU assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H69-1 (USD1) - H53-1 (CSLD) Always Below 1 Ω
      H69-2 (URO+) - H53-2 (CDR+) Always Below 1 Ω
      H69-3 (URO-) - H53-3 (CDR-) Always Below 1 Ω
      H69-4 (ULO+) - H53-4 (CDL+) Always Below 1 Ω
      H69-5 (ULO-) - H53-5 (CDL-) Always Below 1 Ω
      H69-1 (USD1) - Body ground Always 10 kΩ or higher
      H69-2 (URO+) - Body ground Always 10 kΩ or higher
      H69-3 (URO-) - Body ground Always 10 kΩ or higher
      H69-4 (ULO+) - Body ground Always 10 kΩ or higher
      H69-5 (ULO-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here