Click here

PARKING BRAKE PEDAL (for LHD) REMOVAL

Click here
Click here
  1. Click here

    REMOVE AIR CONDITIONING UNIT ASSEMBLY

    (Click here)

  2. Click here

    REMOVE MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD)


    1. A003WRI

      Disconnect the 2 connectors.

    2. Remove the 4 bolts and multi-media module assembly.

  3. Click here

    REMOVE NO. 1 ELECTRICAL KEY OSCILLATOR


    1. A003VST

      Disconnect the connector.

    2. Disengage the clamp and remove the No. 1 electrical key oscillator.

      Note:

      Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.

  4. Click here

    REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ Audio)


    1. A003WWI

      Remove the bolt.

    2. Disconnect each connector.

    3. Disengage the guide and remove the multi-media interface ECU assembly.

  5. Click here

    REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET


    1. A003Z1X

      Disengage the clamp.

    2. Remove the 2 bolts and No. 2 console box mounting bracket.

  6. Click here

    REMOVE YAW RATE AND ACCELERATION SENSOR


    1. A003WLZ

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.

  7. Click here

    REMOVE FRONT FLOOR CENTER REINFORCEMENT


    1. A003YC5

      Remove the 4 bolts and front floor center reinforcement.

  8. Click here

    LOOSEN ADJUSTING NUT


    1. A003Y9XE01

      Remove the lock nut and loosen the adjusting nut.

      Table 1. Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut
  9. Click here

    SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. A003XQWE01

      Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.

      Table 2. Text in Illustration
      *a Turn
      *b Hold
  10. Click here

    REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A003Y94

      Remove the 5 bolts and nut, and separate the No. 1 parking brake cable assembly.

    2. Disengage the cable from the clamp.

    3. A003Z9M

      Disconnect the parking brake switch connector.

    4. Disengage the wire harness clamp.

    5. A003WGE

      Remove the bolt, 2 nuts and parking brake control pedal assembly.