REAR BRAKE FLEXIBLE HOSE INSTALLATION

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. INSTALL REAR FLEXIBLE HOSE


    1. A003XMDE01
      Text in Illustration
      *1 Union Bolt

      Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      33 N*m  { 340 kgf*cm, 25 ft.*lbf }

      Note

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. Install the rear flexible hose with a bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

    3. Install a new clip.

      Note

      Install the clip as far as it will go.

    4. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench Click here.

  2. FILL RESERVOIR WITH BRAKE FLUID

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


  4. BLEED BRAKE LINE


    1. A003WMX

      Disengage the 5 claws and 2 guides to remove the center cowl top ventilator louver.

    2. Bleed brake line.


      1. A003YUP

        Remove the brake master cylinder reservoir filler cap assembly.

      2. Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.

        Brake fluid
        SAE J1703 or FMVSS No. 116 DOT3

      3. Connect the intelligent tester to the DLC3 and turn the power switch on (IG).

      4. Turn the intelligent tester on and enter the following menus: Chassis / ABS/VSC/TRC / Air Bleeding.

      5. Select "Usual air bleeding" on the intelligent tester display, and bleed air from the brake fluid following the instructions on the intelligent tester.

      6. After air bleeding, tighten each bleeder plug.

        Torque:
        front bleeder plug
        8.3 N*m  { 85 kgf*cm, 73 in.*lbf }
        rear bleeder plug
        11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      7. Clear the DTCs Click here.

      8. Turn the intelligent tester off and turn the power switch off.

    3. Inspect for brake fluid leaks.

    4. Install the brake master cylinder reservoir filler cap.

    5. A003WMX

      Engage the 5 claws and 2 guides to install the center cowl top ventilator louver.

  5. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }