PARKING BRAKE PEDAL (for RHD) REMOVAL


  1. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  2. REMOVE REAR CONSOLE BOX ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Tech Tips

    Perform the same procedure as for the LHD model Click here.

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  5. REMOVE CONSOLE BOX INSERT

    Tech Tips

    This is symmetrical to the LHD model Click here.

  6. REMOVE CONSOLE BOX RH

    Tech Tips

    This is symmetrical to the LHD model Click here.

  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

    Tech Tips

    This is symmetrical to the LHD model Click here.

  8. REMOVE CONSOLE BOX LH

    Tech Tips

    This is symmetrical to the LHD model Click here.

  9. REMOVE NO. 3 CONSOLE BOX MOUNTING BRACKET

    Tech Tips

    This is symmetrical to the LHD model Click here.

  10. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET

    Tech Tips

    This is symmetrical to the LHD model Click here.

  11. REMOVE NO. 1 ELECTRICAL KEY OSCILLATOR

    Tech Tips

    This is symmetrical to the LHD model Click here.

  12. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ Audio)

    Tech Tips

    This is symmetrical to the LHD model Click here.

  13. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET


    1. A003YJF

      Disengage the clamp.

    2. Remove the 2 bolts and No. 2 console box mounting bracket.

  14. REMOVE YAW RATE AND ACCELERATION SENSOR


    1. A003WLZ

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.

  15. REMOVE FRONT FLOOR CENTER REINFORCEMENT


    1. A003YC5

      Remove the 4 bolts and front floor center reinforcement.

  16. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    1. A003WPI

      Disengage the 2 claws to remove the No. 2 air duct sub-assembly.

  17. LOOSEN ADJUSTING NUT


    1. A003XCAE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  18. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. A003XQWE01
      Text in Illustration
      *a Turn
      *b Hold

      Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.

  19. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A003VUD

      Remove the 5 bolts and separate the No. 1 parking brake cable assembly.

    2. Disengage the cable from the clamp.

    3. A003XJB

      Disconnect the parking brake switch connector.

    4. Disengage the wire harness clamp.

    5. A003YKJ

      Remove the 2 bolts, nut and parking brake control pedal assembly.