STEERING ANGLE SENSOR REMOVAL

Note


  • Do not remove the steering angle sensor from the spiral cable.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE STEERING COLUMN COVER

    Note

    Removing the steering column cover in the incorrect order will cause the parts to break.


    1. A003ZEW

      Remove the 2 screws.

    2. A003ZVR

      Push the right and left sides of the steering column cover (lower side) to disengage the 4 claws.

    3. A003XDK

      Insert fingers into the opening of the tilt lever of the steering column cover (lower side) to disengage the 2 claws and remove the steering column cover (lower side).

      Tech Tips

      Spread the claws to disengage them.

    4. A003WUH

      Disengage the 4 clips and 2 guides from the steering column cover (upper side).

    5. A003XIV

      Disengage the 2 claws to remove the steering column cover (upper side).

  3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Remove the spiral cable with sensor sub-assembly Click here.

      Note


      • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

      • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

      • Do not remove the steering angle sensor from the spiral cable.