YAW RATE AND ACCELERATION SENSOR INSTALLATION


  1. INSTALL YAW RATE AND ACCELERATION SENSOR


    1. Connect the yaw rate and acceleration sensor connector.

      Note

      Make sure that the yaw rate and acceleration sensor connector is connected securely.

    2. Install the yaw rate and acceleration sensor with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Do not damage the yaw rate and acceleration sensor.

      • Make sure that the yaw rate and acceleration sensor is installed securely.

      • Do not use dropped or damaged parts.

      • Keep the contact surfaces of the yaw rate and acceleration sensor and the body free of foreign matter.

      • Make sure that the sensor is facing the correct direction.

  2. INSTALL CONSOLE BOX LH


    1. Engage the guide and 2 claws.

    2. Engage the 3 clips.

    3. Install the console box LH with the bolt <A> and clip.

  3. INSTALL CONSOLE BOX INSERT


    1. Engage the 2 claws and 2 clips to install the console box insert.

  4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Connect each connector.

    2. Engage the clamp.

    3. Engage the 2 guides and 6 claws to install the integration control and panel assembly.

  5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A003X2P

      Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.

  6. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


  8. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

    Click here