YAW RATE AND ACCELERATION SENSOR REMOVAL

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal, Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


  3. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A003XQZ

      Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.

  5. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A003WBB

      Disengage the 6 claws and 2 guides.

    2. Disengage the clamp.

    3. Disconnect each connector and remove the integration control and panel assembly.

  6. REMOVE CONSOLE BOX INSERT


    1. A003Z6E

      Disengage the 2 clips and 2 claws, and remove the console box insert.

  7. REMOVE CONSOLE BOX LH


    1. A003WSO

      Remove the bolt <A>.

    2. Using a clip remover, remove the clip.

    3. Using a clip remover, disengage the 3 clips.

    4. Disengage the 2 claws and guide, and remove the console box LH.

  8. REMOVE YAW RATE AND ACCELERATION SENSOR


    1. A003WLZ

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.