REAR STABILIZER BAR INSTALLATION


  1. INSTALL REAR STABILIZER BUSHING


    1. A003YRNE01
      Text in Illustration
      *a Stopper

      Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

  2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET


    1. A003W2WE01
      Text in Illustration
      *a Identification Mark
      A003ZV9 Rear of the Vehicle

      Install the rear No. 1 stabilizer bar bracket to the rear stabilizer bushing.

      Note

      Ensure that the identification mark is on the right side of the vehicle.

  3. INSTALL REAR STABILIZER BAR


    1. A003WJ1E01
      Text in Illustration
      *a Identification Mark
      A003YYF Front of the Vehicle

      Install the rear stabilizer bar, 2 rear stabilizer bushings and rear No. 1 stabilizer bar bracket to the rear suspension member sub-assembly with the 4 bolts.

      Torque:
      78 N*m  { 795 kgf*cm, 58 ft.*lbf }

      Note

      Ensure that the identification mark is on the right side of the vehicle.

  4. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Note

    Since the rear stabilizer link assembly LH, rear stabilizer cushions and nut (B) are not reusable, new parts must be installed.


    1. A003ZTN

      Install a new rear stabilizer link assembly LH and 2 new rear stabilizer cushions to the rear No. 2 suspension arm assembly with a new nut (B) as shown in the illustration.

      Text in Illustration
      A003ZV9 Nut (A)
      A003YYF Nut (B)
      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Be sure to install the rear stabilizer cushions in the correct direction as shown in the illustration.

    2. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (A).

      Torque:
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a hexagon socket wrench to hold the stud bolt.

    3. A003XPUE01

      Adjust the rear stabilizer link assembly LH so that A and B are parallel as shown in the illustration.

  5. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as the LH side.

  6. INSTALL REAR SUSPENSION MEMBER BRACE LH


    1. Install the rear suspension member brace LH to the rear suspension member sub-assembly with the 3 bolts.

      Torque:
      35 N*m  { 357 kgf*cm, 26 ft.*lbf }

  7. INSTALL REAR SUSPENSION MEMBER BRACE RH

    Tech Tips

    Perform the same procedure as the LH side.