FRONT LOWER BALL JOINT REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT AXLE ASSEMBLY

    Click here

  2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY


    1. Secure the front axle assembly in a vise.

      Note

      When using a vise, do not overtighten it.

    2. A003XAZ

      Remove the clip and nut.

    3. A003YE0E01

      Install SST to the front lower ball joint assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02050, 09961-02050 )

      Note

      Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).

    4. A003X89E01
      Text in Illustration
      *a Apply grease
      *b Place the wrench here.

      Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02010, 09961-02050, 09961-02050 )

      CAUTION:

      Apply grease to the threads and end of the SST bolt.

      Note


      • Install SST so that A and B are parallel.

      • Be sure to place the wrench on the part indicated in the illustration.

      • Do not damage the front lower ball joint dust cover.