REAR LOWER ARM INSPECTION


  1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY


    1. Inspect the turning torque of the ball joint.


      1. A003ZK1

        Secure the rear No. 1 suspension arm assembly between aluminum plates in a vise.

        Note

        Do not overtighten the vise.

      2. Install the installation nut to the rear No. 1 suspension arm stud.

      3. Move the stud back and forth 5 times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

        Turning torque
        0.5 to 3.4 N*m (5.1 to 34 kgf*cm, 4.4 to 30 in.*lbf)

        If the turning torque is not within the specified range, replace the rear No. 1 suspension arm assembly with a new one.

    2. Inspect the dust cover.


      1. Check the dust covers for cracks or grease leakage.