STEERING KNUCKLE INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL STEERING KNUCKLE


    1. Secure the steering knuckle between aluminum plates in a vise.

      Note

      Do not overtighten the vise.

    2. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY


    1. Secure the front axle assembly in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Install the front lower ball joint assembly to the front axle assembly with the nut.

      Torque:
      71 N*m  { 724 kgf*cm, 52 ft.*lbf }

    3. Install a new clip.

      Note

      Further tighten the nut up to 60° if the holes for the clip are not aligned.

  3. INSTALL FRONT AXLE ASSEMBLY

    Click here