Click here

CRUISE CONTROL SYSTEM, Diagnostic DTC:P0575

Click here
Click here
DTC Code DTC Name
P0575 Cruise Control Input Circuit
Click here

DESCRIPTION

This DTC indicates the internal abnormalities of the power management control ECU.

DTC No. DTC Detection Condition Trouble Area
P0575

When both of the following conditions are met:


  • STP signals input to the power management control ECU supervisory CPU and control ECU are different for 0.15 seconds or more

  • 0.4 seconds have passed after cruise cancel input signal (STP input) is input to the power management control ECU

 Power management control ECU
Tip:

The power management control ECU receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the power switch is turned off.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    READ OUTPUT DTC (P0575)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Clear the DTC (Click here).

    5. Perform the following to make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the malfunction cannot be detected.


      1. Drive at a speed of between approximately 40 km/h (25 mph) and 200 km/h (125 mph).

      2. Turn the cruise control switch (ON-OFF button) on.

      3. Push the -/SET switch to activate the cruise control.

    6. Enter the following menus: Powertrain / Cruise Control / DTC.

    7. Check for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC P0575 is output B

  2. Click here

    USE SIMULATION METHOD TO CHECKClick here

  3. Click here

    REPLACE POWER MANAGEMENT CONTROL ECUClick here