HEADLIGHT LEVELING SWITCH INSPECTION


  1. INSPECT HEADLIGHT LEVELING SWITCH


    1. Voltage Ratio Inspection.


      1. Disconnect connector H135 from the headlight leveling switch.

      2. A003VDXE01
        Text in Illustration
        *a

        Front side of wire harness connector

        (to Headlight Leveling Switch)

        Using SST, measure the voltage between terminals H135-5 (B) and H135-1 (E). (Voltage A)

      3. Connect connector H135 to the headlight leveling switch.

      4. A003Z39E01
        Text in Illustration
        *a

        Component with harness connected

        (Headlight Leveling Switch)

        Using SST, measure the voltage between terminals H135-2 (T) and H135-1 (E) from backside of the connector. (Voltage B)

      5. Divide Voltage B by Voltage A to obtain the voltage ratio.

        Standard Voltage Ratio
        Switch Position Voltage Ratio (%)
        0 7 to 13
        (0.5) 12.3 to 18.3
        1 17.7 to 23.7
        (1.5) 23.0 to 29.0
        2 28.3 to 34.3
        (2.5) 33.7 to 39.7
        3 39.0 to 45.0
        (3.5) 44.7 to 50.3
        4 49.7 to 55.7
        (4.5) 55.0 to 61.0
        5 60.3 to 66.3

        Tech Tips

        If Voltage A is 12 V and Voltage B is 10 V, the voltage ratio (10/12=0.83) will be 83.3%.

        If the result is not as specified, replace the headlight leveling switch.

    2. A003X82E01
      Text in Illustration
      *a

      Connector disconnected

      (to Headlight Leveling Switch)

      LED Illumination Inspection


      1. Connect the negative and positive battery terminals to the connector according to the table below.

        Tester Connection Switch Condition Specified Condition
        3 (ILL+) - 4 (ILL-)

        Battery positive (+) a 3 (ILL+)

        Battery negative (-) a 4 (ILL-)

        		 Illuminates